Bassface DB1.2 2000w 1Ohm Class D Monoblock Subwoofer 12v Power Amplifier

81 In Stock

RRP: £194.99
£155.99
  • Includes Free UK Delivery on Basket Orders Over £50.00
  • Express Delivery also available

Now shipping Version 4 of this product - The new circuit board also allows us to announce 1 ohm stability which further broadens the range of system applications and subwoofer configurations that DB1.2 can be used in. The new DB1.2 offers its user an outstanding balance of power and sound quality. The DB1.2 was developed specifically to be a heavier duty version of the DB1.1. Building on the series architecture of an oversize power supply and efficient heat-sink design the DB1.2 will run hard for extended listening periods without being overworked. With Class D topology, the DB1.2 is highly efficient in power exchange and delivery; less power wasted, less heat generated, less distortion and longer service life. The circuit design is robust enough to deliver powerful bass while remaining poised and refined, producing a balanced accurate sound across the full bass audio spectrum. At detail level we included 2 positive and 2 negative speaker terminals making it easier for you to connect two subwoofers or dual voice coil subwoofers to the one amplifier. Naturally there is a full set of sound controls; variable low pass, variable subsonic filter and a parametric bass boost (frequency and level). For those tracks that deserve “just that bit extra” we also included a wired cockpit bass remote for on the fly adjustment.

V1 ? The V1 production model had a short life and only 300 units were produced. V2 ? Moved production to a new facility and changed the design completely. Featured increased power output and ability to link 2 amps to one output. V3 ? Addressed the issues with phase alignment making it complicated to link 2 amps and simplified this. It also added better terminals and different remote control, as well as slightly higher power output. V4 ? 2016 styling badge, as well as increased overall performance. 16v ready. Quoted theroetical output figures revised after testing. We have discussed a V5 model which will be the same but will incorporate a fan to lower running temperatures further but this has not yet been scheduled for build.

Product Data

  • Brand: Bass Face Car Audio
  • Model: DB1.2
  • UPC: 700175821683
  • Sold As: Single
  • Bass Face Series: Assault Series
  • Version: 3
  • Weight: 3150 (g)
  • Product Length: 280 (mm)
  • Product Width: (mm)
  • Product Height: 62 (mm)

Key points

  • Latest Version Of Our Mid Range Compact Mono
  • Highly Efficient Class D Topology
  • Variable Bass Boost Level and Frequency
  • Variable Low Pass Filter
  • T.D.O.S. Amplifier Protection Circuitry

More Data

  • Variable Subsonic Filter
  • Up To 6V Ready Pre Amp Input Stage
  • O.P.S. Oversized Power Supply
  • Thermally Efficient Heatsink Coating
  • Low THD Audiophile Components
  • High Density Cast Aluminium Heatsink Body
  • Max Power : 2000
  • Max RMS Power : 1000
  • RMS 4 Ohm Per Channel : 500
  • RMS 2 Ohm Per Channel : 750
  • RMS 1 Ohm Per Channel : 1000
  • Amplifier Frequency Response (Hz) : 10-180
  • Amplifier THD Continous 4 Ohm 1Khz/100Hz (%) : <0.1
  • Amplifier Signal To Noise Ratio (db) : >96
  • Amplifier LPF (Hz) : 40-180
  • Amplifier Bass Boost (Db) : 0-12
  • Amplifier Boost Frequency (Hz) : 30-80
  • Amplifier Subsonic Filter (Hz) : 15-50
  • Amplifier Audio Signal Input Voltage (V) : 0.2-6
  • Amplifier LPF Slope (Db/Oct) : 12
  • Amplifier Subsonic Filter Slope (Db/Oct) : 12
  • Amplifier Topology : Class D
  • Amplifier Fuse Rating (Amps) : 120
  • Amplifier Power Wire Input Gauge (AWG) : 4
  • Recommended Wiring Kit and Accessories : PWK4.1 RCA5.1
  • Minimum Recommend Final Load Per Channel (Ohms) : 1

Whats In The Box?

  • 1 x High Performance Mono Amplifier
  • 1 x Bass remote level control
  • 1 x 5m level control cable
  • 4 x Self tapping screws
Thompsons

Specification


Close Clear All